MIG plug welding

slot weld and plug weld   Dan slot leonardo da vinci

The suggestions I did find were changing the pulse profile , using a larger hole and using a slot instead of a hole; I

FIGURE 9 SURFACING, PLUG AND SLOT WELDS the first member Slot Weld the hole Fillet Weld This type weld is shown in figure 6, view L The seam weld uses a similar process as a spot weld but in an elongated fashion There is no preparation like a plug or slot weld, rather the weld projects

avatar slot 88 Slot weld is also shown in the figure above It is quite similar to the plug weld, except that the hole is not circular, it is an elongated hole Per AISC table , fillet welds in holes and slots are allowed in tension and is allowed to be neglected in design However, plug and slot